Brushed-nickel kitchen faucet and pale quartz countertop beside a window overlooking a quiet autumn backyard.

Who Can Tap Into Stokesdale's New Water Main, and What It Costs

A rezoning case in the Stokesdale Town Council's November 12, 2026 meeting packet covers a property on US Highway 158 that is about 0.2 miles from the fire station. Its water and sewer provider is listed as "Private well and Septic." The town's water line is about 2,800 feet away, and the applicant has not asked to connect.

That's how water usually works in Stokesdale. Being close to the fire station, a main road or a hydrant doesn't put a home on town water. Two things decide it. The town limits determine whether a property can get service at all, and an existing tap largely sets the cost of getting it. Both matter more this fall, because Stokesdale just finished putting nearly three miles of new pipe in the ground.

Town limits decide who can get service

The Town of Stokesdale's water service page says the municipal system serves residents within the town's incorporated limits. The town also says the system supports fire suppression in the Stokesdale Fire District and surrounding districts. Water service and hydrants are limited to customers within those limits, with one grandfathered exception. Existing customers in Phases 1 and 2 of the Coldwater Subdivision, which sits outside town limits in Forsyth County, keep their service. The exception is limited to properties on a recorded 78.279-acre tract and to lots with at least 25% of their surface area inside that tract. No other Coldwater properties can get town water unless they are annexed into Stokesdale.

It's a small system. Stokesdale doesn't treat its own water. It buys it from Winston-Salem. In the billing cycle from September 20 to October 16, 2026, the town mailed 953 water bills and sold an average of about 253,000 gallons a day to its customers. With a system this small, treat town water on a Stokesdale listing as a feature to verify, not one to assume.

This post covers water only. If you're also looking at larger parcels, our post on how Present-Use Value taxation affects Stokesdale acreage explains the other line on those listings that needs a closer look.

What it costs to connect

For a home that qualifies, the cost of joining depends mostly on whether a tap already exists. The town's tap fee schedule, effective July 1, 2026, lists these totals:

Connection type Tap Meter Installation Capacity use Deposit Total
3/4-inch, new tap $4,200 $300 $120 $750 $50 $5,420
3/4-inch, developer-installed tap infrastructure N/A $300 $120 $750 $50 $1,220
1-inch tap $5,400 $550 $120 $1,000 $50 $7,120
2-inch tap $10,440 $1,650 $240 $1,500 $50 $13,880

For a typical house, the gap is $4,200, the cost of the tap itself. Where a builder already ran the tap infrastructure, the tap-schedule charges come to $1,220. Where nobody did, they come to $5,420. Either way, a new account also carries the $25 setup fee listed below. Two homes on the same road can fall into different rows of this table.

Monthly costs come from the town's usage fee schedule, also effective July 1, 2026:

  • Customer service fee of $25.50 a month
  • $6.70 per 1,000 gallons for residents
  • $8.71 per 1,000 gallons for non-residents
  • One-time deposit of $50 for owner-occupied homes or $175 for renter-occupied homes, plus a $25 account setup fee
  • $75 disconnect or reconnect fee, and $250 to abandon a tap

Here's what that means for a household using 5,000 gallons in a month. Under the posted schedule, a resident customer would pay $59.00 and a non-resident customer would pay $69.05. Hazen and Sawyer's Water Rate Study was on the council's November 12 agenda as part of the town's water system assessment project. Check the current schedule before you plug these numbers into a budget.

There's one more cost to know about. Residential properties with a pool or in-ground irrigation need an approved backflow prevention device, and it has to be inspected every three years. The application fee for the device is $50.

Why the NC-65 main was built

The new pipe exists because of a weak point. Guilford County's description of the project says Stokesdale's water came in through one main on US Highway 158. In 2018, rain from the remnants of Hurricane Michael caused a landslide that broke that line. The county used federal American Rescue Plan Act money to fund about four miles of new main, giving the town a second inlet into the Town Core. The county says the project will also improve water quality and fire protection and bring service to residents the town system has historically underserved. The adopted budget is $3,113,038. By the end of June 2026, $1,811,150.76 had been spent.

The Coldwater Road and NC-65/Belews Creek Road extension built this year is paid for through that same Guilford County ARPA funding. Its route ran along Coldwater Road from Cold Water Terrace to NC Highway 65, then along NC 65 to Oak Level Church Road. The plans called for about 2,800 feet of 8-inch main on Coldwater Road and about 11,545 feet on NC 65, roughly 2.7 miles in all. According to the town administrator's report in the November 12 council packet, contractor Classic City Mechanical has finished installing the main, and the new fire hydrants are painted red with white caps. Hazen and Sawyer ran flow tests at three hydrants:

  1. Coldwater Road, just south of NC 65: 970 gallons per minute
  2. NC 65 at Belews Ridge Road: 1,000 gallons per minute
  3. NC 65 at Fieldstream Drive: 910 gallons per minute

The state signed off on the corridor on November 3. That day, an inspector with the North Carolina Department of Environmental Quality approved the restoration work and cleared the contractor to remove the temporary erosion controls. Classic City Mechanical will also take down the two project signs at either end of the NC 65 corridor. Hazen and Sawyer expects to do its final inspection as closeout finishes. The town has been fully reimbursed through Guilford County's ARPA grant for each of the first seven pay applications and expects to finish the final reimbursements before the end of December 2026. The October water report lists three meter applications on hold for the Coldwater Road and NC-65 extension.

The rest of the system got work this fall too. Utility Service Co. finished restoring the town's 300,000-gallon elevated tank and did its final inspection on October 16. According to the Northwest Observer's report on the tank contract, the new white finish with red block lettering replaces faded blue paint that Mayor Pro Tem Derek Foy joked looked like "a rotten blueberry." The council chose a 10-year inspection and maintenance plan for the tank. Inframark is also installing a cellular SCADA monitoring system with a pressure-reducing valve retrofit. The contract totals $262,114.18 after a change order, and the revised completion date is December 15, 2026.

All of this makes the town's system more resilient for the people already on it. It doesn't change who can join. The service rules on the town's water page still tie eligibility to the incorporated limits, with Coldwater as the only exception.

Questions to settle before you write an offer

With Stokesdale's mix of town water and private wells, you'll learn the most from a few questions asked early:

  1. Which source serves this address today? Ask Town Hall at (336) 643-4011 or [email protected]. Don't rely on how close the home is to a hydrant or main.
  2. Is the parcel inside the incorporated limits, or on the Coldwater tract? If neither applies, town water isn't available under the current policy unless the property is annexed.
  3. Is there an existing tap? That's the difference between $1,220 and $5,420 in tap-schedule charges for a 3/4-inch connection.
  4. Will you be a resident or non-resident customer? The usage rate changes with that status.
  5. Does the home have a pool or in-ground irrigation? Then budget for a backflow device and its three-year inspection cycle.

This is general information, not legal or financial advice. Confirm the details for your own property with the Town of Stokesdale and the right professional before you rely on them.

FAQ

Does the new NC-65 main mean homes along it can connect now? The main is installed and in closeout, and three applications tied to the extension were on hold as of the October report. Eligibility still follows the town's service policy, so check with Town Hall about a specific address.

Where does Stokesdale's water come from? The town buys its water from Winston-Salem. In the September 20 to October 16, 2026 billing cycle, it bought about 7.14 million gallons from the Winston-Salem/Forsyth County Utility Commission.

When are meters read? According to the town's water FAQ, meters are read on the second Saturday of each month. Card payments carry a $3 or 3.5% fee.

If you're weighing a Stokesdale home and want to know its water source, tap status and rate tier before you make an offer, Kathy Haines can work through those questions with you property by property. Browse current Stokesdale homes for sale, then schedule a consultation to talk through the ones on your list.

Work With Kathy

Kathy, a Triad native since birth, brings 25 years of real estate expertise, spanning luxury homes to first-time buyers. Certified in various specialties, she's committed to top-notch customer service. Join Kathy as she continues her mission to make the Triad the best place to live, work, and play!

Follow Me on Instagram